chanelink logo
CHANELINK
Português

Pointer Offset Negative Value

Categorias:
Laser
Tags:
319
1
Ver tradução
2023-08-30

I have two problems . . .

 

1. I have been trying to use pointer offset in the device settings but Lightburn generates an error on Start if I enter a negative value in the Y axis setting. This happens even if the laser head is placed well within the work area. I’ve seen this done in a YouTube video using Lightburn and my same make/model laser engraver.

 

2. I executed one material burn test but all subsequent attempts error out at 36% for being “out of bounds” regardless of the starting position. What can I check?
C

    • Jen

      2023-08-31
      It’s likely you’re not following one or both of the two conditions:

1. Homing the laser prior to each session
2. Avoiding moving the laser by hand after homing. Use jogging controls exclusively.
If either of these conditions are not met then the controller is losing position and unable to work properly. Try again while following these conditions.

Some lasers offer the ability to attach an offline controller screen. Perhaps that or a wireless keyboard could offer you some flexibility.
        Ver tradução
        Responder
      Recomendações relevantes
      Coletar
      Relatório