G code error,Problem with engraving a photo

roy

Categorias:

Laser

Tags:

LightBurn

113

Ver tradução

2024-01-18

Problem with engraving a photo, laser starts in lightburn software and then freezes, don’t know where to look for the cause. Anyone have some idea? Photo of error

Liam

2024-01-19

Disable Gcode Clustering
AS far as i know Neje does not support it
Should fix the issue
Also, does your NEJE have Z axis (up and down)? If not, disable those as well (top right corner)

Ver tradução

Responder

Recomendações relevantes