Lightburn settings for NEJE Master 2SPlus

Vasili

Kategoriler:

Лазер

Etiketler:

LightBurn

386

Çeviriyi gör

2023-07-03

Hi
Trying to setup NEJE Master 2S plus and Having problems with settings
The homing works correctly but the move command is reversed. For the NEJE home shows it is X0 Y420mm.
When I use the move command the X axis moves correctly but the Y axis is reversed I use the up arrow to get the laser to move down and the y axis position counts higher.
I have my origin position at bottom left.

Robert Evans

2023-07-04

In LightBurn, click Edit, click Device Settings, and change the origin to Top Left in the Device Settings window. Carefully click OK at the bottom of this window to make sure the settings take.
This should not have any effect on homing. Origin and Home can be different.

Çeviriyi gör

Yanıtla

İlgili öneriler