Not engraving the position im asking it too?

roy

Kategoriler:

Lazer

Etiketler:

LightBurn

228

Çeviriyi gör

2023-08-14

hi all I have a neje master 2 plus laser and using lightburn but totally new too this .
so ive installed neje driver correctly then lightburn has auto found laser and input limits correctly ye .
now I write text on screen and say centre this but when I go to engrave the laser just goes to the end fully then starts engraving how do I get this in correct position please thanks.

Jamie

2023-08-15

Do these 3 things and then retest:

1. home the laser
2. after homing, do not move the machine by hand, use jogging controls exclusively to move the laser head
3. change “start from” mode in Laser window to “Absolute Coords”
Retest. Do you still experience the issue? If not, always follow the first 2 rules. Stick to the 3rd until you’re well comfortable with your laser to experiment with the 3rd.

Çeviriyi gör

Yanıtla

İlgili öneriler