Alarm 8 failed to return to its original position

Farouk

Danh mục:

Tia laze

Xem bản dịch

03-27

Hello,
I have a big question.
My laser is Atomstack A20 Pro.
Due to the laser consistently displaying alarm 8, I rewired it, but this did not help as the laser still displayed error message alarm 8. The laser circled around the project I wanted the laser for, but did not return to zero.

David

03-31
```
Der Laser erkennt einen Endschalter als gedrückt. Gib mal in der Konsole das Fragezeichen “?” ein, und poste hier, was als Rückgabe kommt. Daran kann man das eventuell erkennen.
```
Xem bản dịch

0

Trả lời
- Farouk
  
  : Thank you for your help... Here comes the... error:5 The referencing cycle is not enabled in your Grbl settings. ? <Idle|MPos:158.000,158.000,0.000|Bf:15,127|FS:0,0|Pn:PXY|Ov:100,100,100> ok
- David
  Trả lời
  @Farouk
  
  : I think the laser is located somewhere on the working surface, not at the edge? It detects whether all limit switches are pressed: Pn:PXY， This means that x and y permanently activate it. Does your laser have a limit switch? If not, returning to the correct position is meaningless and will also be disabled (resulting in error 5). Otherwise, we can still open it.
- Farouk
  Trả lời
  @David
  
  : Ja der Atomstack A20 pro hat 2 Endschalter. error:5 Der Referenzierzyklus ist in Ihren Grbl-Einstellungen nicht aktiviert. ? <Idle|MPos:158.000,158.000,0.000|Bf:15,127|FS:0,0|Pn:PXY|Ov:100,100,100> ok $$ $0=20 $1=25 $2=0 $3=0 $4=0 $5=0 $6=0 $10=3 $11=0.010 $12=0.002 $13=0 $20=1 $21=0 $22=0 $23=3 $24=300.000 $25=3000.000 $26=250.000 $27=1.000 $30=1000.000 $31=0.000 $32=1 $37=0 $40=0 $100=80.000 $101=80.000 $102=80.000 $103=100.000 $104=100.000 $105=100.000 $110=6000.000 $111=6000.000 $112=6000.000 $113=1000.000 $114=1000.000 $115=1000.000 $120=1000.000 $121=1000.000 $122=1000.000 $123=200.000 $124=200.000 $125=200.000 $130=400.000 $131=400.000 $132=200.000 $133=300.000 $134=300.000 $135=300.000 ok ALARM:8 Rückkehr zur Ausgangsposition fehlgeschlagen. Der Zyklus konnte den Endschalter beim Abziehen nicht löschen. Versuchen Sie, die Abzieheinstellung zu erhöhen, oder überprüfen Sie die Verkabelung. ok Grbl 1.1h [‘$’ for help] [MSG:Check limits] [MSG:‘$H’|‘$X’ to unlock] [MSG:Caution: Unlocked] ok
- Khác 5 phản hồi