chanelink logo
CHANELINK
简体中文

Erasing the job/file in memory

分类:
激光
标签:
213
1
查看翻译
2023-04-26

Hi, using a Boss 1420, a Mac and 1.3.01 Lightburn
I can see a temp job on the console screen. If I hit START, it runs, even if the machine has been reset and turned off and on.
I followed the helpful video showing how to go to PAGES and then OTHER+ and delete all, but I don’t see any files in ‘pages’. Just the one file on the console, the one that causes Lightburn to say the laser is busy.
without going all the way to factory reset, how to clean this out and get the laser to wake up again and talk to Lightburn?
thank you!
C

    • Gilbert

      2023-04-27
      This is usually not a good idea, you loose all the vendor data and you could brick the machine, at least it wouldn’t run…

In the file window of Lightburn you should be able to refresh the contents and delete all or any one of them… Might try just deleting them all from Lightburn.

I’ve never seen a temp job… how do you tell?
        查看翻译
        回复
      相关推荐
      收藏
      举报