chanelink logo
CHANELINK
English

XTool D1 Pro and Lightburn capatablity

Categories:
Laser
Tags:
237
1
See translation
2023-03-08

I am not sure what the issue is but I had a Jiccoda L1 and switched to the XTool D1 pro and lightburn will not engrave properly. It starts a piece of the project then it either moves up slightly or down from where it started and continues to engrave completely screwing up the project. Also text in the projects are turned upside down and not in the place they were designed to be.

C

    • Gilbert

      2023-03-09
      I assume you are not using the red crosshairs for framing. Please correct me if this is not the case. If you are not using the crosshairs then you’ll want to disable any pointer offset configured in Edit->Device Settings.

Are you on a version of LightBurn older than 1.3? If so, you’ll need to reorient your projects since the machine origin of your old machine was likely different than what the xTool is. 1.3 introduced auto-flipping of projects to adapt to different laser origins. So a file saved as a top-left origin will auto-flip when opened in a bottom-left profile.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report