I dont have the Cut drop down when I need to cut
Categories:
Laser
236
1
0
2023-03-27
C
jessie
2023-03-28There is no ‘Cut’ setting you would use ‘Line’ and adjust the power, speed and the number of passes (higher power, lower speed etc.) accordingly to be able to cleanly cut through. Each material will be different though, so you may find the ‘material test’ useful, this can be found under the ‘laser tools’ dropdown
0Reply
Relevant recommendations
-
My Ortur 2 S2 laser wont turn on
1 Reply2023-06-06 -
Proper settings to engrave image
2 Replies2023-02-23 -
engraving shapes stretched
2 Replies2023-03-29 - 2023-09-25