How to slow down rapid moves at the start of a Frame
I know this is a simple setting, but I’m not getting it. I looked at another post and the solution was what I thought it would be (acceleration) but I change it, write it to the machine and it still does it.
I’ve attached my rotary unit to my machine and I go to frame the test image. It rapids to whatever start position and kicks off the tumbler because it is too fast.
Like I said I changed the acceleration in machine settings (would be “y” axis) and the rollers and the X both rapid to start. I don’t mind the X rapid, but the roller is too fast. Anyone know what I’m missing here?
Also, bonus question, Enable rotary is true in machine settings but unchecked on the laser tab. I assume both need to be checked but why two if they aren’t related?
Henry
2023-04-28I use the framing buttons in the move window. You can specify the speed and slow it down. I also set the angle in the layer so the engrave begins at the same place as i have set the origin so it doesn’t have to jump across the design to start.
0Reply
- 2023-06-15
- 2023-05-09
- 2022-11-21
- 2022-12-21
- 2022-10-31
