Hello when I cut wood engraved lines appear the paths of the laser
Categories:
Laser
194
1
0
2023-04-27
C
Robert Evans
2023-04-28This is usually caused by the $32 variable set to 0. It needs to be in laser mode, so it turns the laser off between cuts… A spindle isn’t turned off between operations … like you do with a laser. Enter $32=1 in the console and see if that fixes your issue. You should follow the Lightburn Setup for GRBL…
0Reply
Relevant recommendations
-
Dirt in the cut
1 Reply2023-06-20 - 2022-10-18
- 2022-05-30
-
Change settings in mid burn
1 Reply2023-03-20