chanelink logo
CHANELINK
English

Xtool DI 40 Watt crashes when I push Home

Categories:
Laser
Tags:
144
1
See translation
2023-05-04

When I hit “home” the laser moves all the way left then up to the upper most corner and when it gets to the top it still wants to go further and the belts keep turning for about 5 seconds. I’m afraid this will damage the motors or belts. I don’t know if this is a software or hardware issue.

C

    • Jen

      2023-05-05
      This is for sure something the machine is not handling properly. LightBurn is not involved in the actual homing process other than requesting that it happens.

xTool D1 Pro has proximity sensors that are used for homing on both the X and Y axes. Sounds like for some reason the Y sensor is not getting triggered or not working properly.

Look carefully at the machine to see if there’s a physical reason why the Y sensor is not able to be triggered. If there’s no physical impediment check that there’s no electrical reason it might not be working. Check for loose or improperly connected components. If you don’t seen an electrical issue you could have an electronic issue with one of the components or on the controller board.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report