Cannot cut round holes
Categories:
Laser
273
1
0
2023-05-11
I have a problem cutting small holes 1.8mm with my Sculpfun S9 20W laser. Holes are not round. Attached picture. I have activated option to reduce backflash, but so far no luck getting the small hole round.
Do you have any suggestions?
C
Liam
2023-05-12This is most likely due to mechanical backlash or binding. Check that pinion gears are not loose and review belt tension. Disable the “hide backlash” until everything is optimized mechanically. For binding make sure that everything is moving freely and without friction point. Adjust eccentric nuts if required to reduce overtension scenarios.
0Reply
Relevant recommendations
- 2022-10-17
- 11-11
- 2023-02-24