Was working fine yesterday then today says laser disconnected
Categories:
Laser
425
1
0
2023-06-08
C
Keegan
2023-06-09Loose cable? Had this happen before and a quick check for physical wiring/USB cable was the culprit. Then I had to shutdown the PC and reboot to get LightBurn to see the device but it’s working fine now. I should add that I incorporated a strain relief to the cable that plugs into the laser cabinet. It’s simply a magnet with a hook stuck slightly above the USB port and a wire tie to hold the end of the cable more securely in place.
0Reply
Relevant recommendations
- 2022-09-05
- 2023-06-06
- 2024-12-25
-
Power supply issue
1 Reply2024-01-04 - 2023-09-06