Pits/holes in glass around edges
Categories:
Laser
319
1
0
2023-06-12
C
Vasili
2023-06-13I use lbt100 spray for the co2, when I tried it with my ss laser, it didn’t work out too well… My communications with them was it was made for co2, not ss led type lasers… I think both Cermark and LBT100 are about the same type/kind of spray. Can you scrape it off? That would indicate it isn’t bonding to the material properly… Have you used it before with good results?
0Reply
Relevant recommendations
-
Cross Hairs for the origin
1 Reply2023-04-14 - 2024-12-25
- 2022-06-15