Problème de Gravure floue (Fuzzy Engraving Issue)
Categories:
Lazer
287
1
0
2023-06-28
C
Liam
2023-06-29The engrave speed setting is in the Cuts / Layers Window. If it is not showing, click Window, and scroll down to select Cuts / Layers. If the check mark is already there, the window is Active and may be on the screen or on a tab under another window. In the Cuts / Layers window, double-click the layer that you would like to adjust. You may find that the ‘blurr’ is caused by incorrect ‘Scanning Offset’ This page should translate reasonably well.
0Reply
Relevant recommendations
-
laser cutting near me
0 Replies2023-01-04 -
Power supply wiring
1 Reply2023-02-27 - 03-20
-
Read from the controller
1 Reply2023-06-10