LightBurn se para en medio de un trabajo ( stops in the middle of a job )
Categories:
Laser
193
1
0
2023-07-05
C
Jen
2023-07-06Electromagnetic (radio) interference is the greatest reason for jobs stopping. The next greatest reasons are screen savers, Sleep mode and USB suspend (Selective Suspend) of the communications ports. "when I execute a file with small details it stops suddenly without emitting light or moving and in LightBurn the timer continues running, but not the progress bar," Because of this behavior, I am thinking the buffer in the controller is large, and when the buffer is full and communication pauses this creates enough quiet-time to allow the USB port to time-out. It may be most productive to slow the communication speed so the buffer does not fill up or need to pause communication to catch up. You may also want to review System Settings and shut off the ‘power saving’ options…
0Reply
Relevant recommendations
-
Scan off-set in Lightburn
2 Replies2023-03-15 - 2023-04-28
- 2023-05-17
- 2022-10-12