G-code words consist of a letter and a value. letter was not found. error
Categories:
Laser
258
1
0
2023-08-23
C
Kevin
2023-08-25I suspect you have “gcode clustering” enabled in Edit->Device Settings. If you see it enabled, disable it and try again. If it’s not disabled do the following: 1. Push Devices button in Laser window 2. Click on the name of your laser one time 3. Take a screenshot 4. Post screenshot here 5. Take a screenshot of Edit->Device Settings and also post here
0Reply
Relevant recommendations
- 2022-12-24
-
engraving shapes stretched
2 Replies2023-03-29 - 02-21