Best way to create raised lettering for wood cut?
Categories:
Laser
149
1
0
2023-09-04
I’m hoping to create a raised letting ink stamp.
Can someone tell me the best way to create a rectangle around these letters, then tell Lightburn to cut around the letters to until it reaches the rectangle?
C
Liam
2023-09-051. Create rectangle 2. Put letters and rectangle on same layer 3. Set layer cut mode to Fill
0Reply
Relevant recommendations
- 2022-09-27
- 2024-12-13
- 2022-10-14
-
Upgrading module
1 Reply2023-07-01
