chanelink logo
CHANELINK
English

Speed and Power settings not being saved in .nc file [AtomStack x20 Pro]

Categories:
Laser
Tags:
280
1
See translation
2023-09-08

I’ve just started playing around with Lightburn and my new Atomstack X20 Pro.
I created a design to engrave, and set the speed and power in the Cuts/Layer tab, and then saved the .nc file. I transfer the file to a thumb drive (with a TF card) and insert it’s TF card into the Atomstak.
However, when I open the file and start the engraving, the little hand-held terminal/control says it’s using 100% Power and Speed.
Is there something else I need to do to get these settings to apply?
Is there a way to see if they are in the g-code (or add it manually)?
Thanks!

C

    • Jamie

      2023-09-11
      "This is a vector object? then draw a piece that reachs both ends, and boolean them together…"

It’s likely that whatever the configured speed is in gcode will show as 100%. The percentage may be meant to show changes from base (100%) using on-screen overrides.
Test that the speeds for engraving are indeed changing by making one with very slow speed and one with very high speed. The difference should be apparent.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report