Is there a way to keep a layer setting from being persistent in new projects?
Categories:
Laser
414
1
0
2023-09-12
C
Vasili
2023-09-13Not sure if I’m understanding the question, but if you set up a layer how you want it for most projects, you just click " Make Default " in the Cut Settings editor. Then if you make changes, like you described, then to go back just click " Reset to Default ". Otherwise, it will always have the last changes you made to it.
0Reply
Relevant recommendations
-
Output to laser at a 90 degree angle
2 Replies04-08 -
Power supply issue
1 Reply2024-01-04 - 2022-09-13
- 2023-08-01