Added the Ortur Extension but it doesn’t Frame
Categories:
Laser
45
1
0
2023-12-26
Hello all. I hooked up my Ortur Extension to engrave longer pieces and changed my settings but when I hit Frame the laser goes to about the middle right of the project and just stops. Any suggestions? Seems to be only this particular project.
C
Nugent
2023-12-27You likely didn’t extend the Y-axis Max Travel GRBL configuration ($131). Go to Edit->Machine Settings and adjust $131 to your new Y height.
0Reply
Relevant recommendations
- 2023-05-12
- 2024-01-04
- 2023-07-04
- 2023-12-14
- 2022-12-12
