RDC6332G Fan control

在运行灯口加一个继电器给风扇就行了

Hello! You can connect the fan through the WIND port of the controller, and when the fan control is enabled, the port outputs the fan control signal, otherwise it is other special control signals. When the fan is connected and the fan control is enabled, the switch of the fan can be set separately in each layer, if the external relay is connected, the relay coil is turned on when the fan is turned on, and the relay coil is cut off when the fan is turned on. to meet your needs.

You can use the working status signal of the controller, labeled as the ‘status’ signal pin, to connect a relay and use the normally open contact of the relay to control the on/off of the fan. After this design, when the controller is working, the ‘status’ signal will drive the relay to conduct, causing the fan to work. After the work is completed, the ‘status’ signal will drive the relay to close, causing the fan to shut down

for example