chanelink logo
CHANELINK
English

parameter issues

Categories:
Laser
40
1
See translation
01-11


Hi, I am are having some problems with my unmarked laser. The laser head cannot find home, the parameters are messed up so, the laser head hits the sides of the machine, and it does not cut the right size anymore so I think the scaling is off as well. The laser was working just fine a couple of weeks ago. I use RdWorks to run the laser. If anyone has any tips on how to fix it I would greatly appreciate it.

C

    • blue sea

      01-11
      Hello! Please check whether the limit of the equipment is normal and whether the directional polarity of the shaft is correct. If the limit is correct, then re-set the format size and step distance of the manufacturer's parameters, after the setting is successful, you can refer to the software manual for the parameter setting of each function, and remember to save the backup manufacturer's parameters on the computer after completing the parameter setting, in case the parameters are lost next time. The software manual can be downloaded from our official website: https://www.rdacs.com/en
        See translation
        Reply
      Relevant recommendations
      Collect
      Report