RDC6563FG connection with Fuji Alpha5 smart Plus

Referring to this, during debugging, the brake can be directly connected to a 24V switch power supply for forced release

• aO5ZCpeb

  : Thank you very much, now I can continue Vielen Dank jetzt kann ich weiter machen

Please excuse me as I don't speak English. I work with a translator
Thank you very much, everything is set like this but unfortunately it doesn't work, it says Encoder Nothing in the display. Sorry, do you have any idea what I might be doing wrong? Until now I have only ever worked with stepper motors and actually have no idea about servo motors

Vielen Dank alles so eingestellt aber leider klappt es nicht,
es steht im Display Encoder Nothing .
Sorry haben Sie da noch eine Idee was ich wohl falsch mache ?
Habe bis jetzt immer nur mit Stepper Motoren gearbeitet und eigentlich keine
Ahnung von Servo Motoren 

• D8794267

  : Please take a photo with your mobile phone to see the nameplate on the servo driver and servo motor in your hand, I see that the picture of the manual you sent before is different from the manual I downloaded, you must first make sure that we are talking about the same driver. After the servo drive parameters are set, restart it again to see if the parameters are set correctly. Be sure to make sure that the brake signal of the motor can be released, you can connect the brake signal of the motor directly to the 24V switching power supply,and when the line between the driver and the 6563FG is not connected, the motor shaft can rotate freely after the brake is released When the cable between the driver and the 6563FG is connected, the motor shaft cannot be rotated because it is enabled. Before pressing the Z-axis move button, you need to make sure that the ALM and SON lights at the Z-axis indicator on the motherboard are lit, and the servo drive does not generate an alarm, if you press the Z-axis move button at this time and still prompt that the encoder is none, then the SON light should be off, and the ALM light has been on, at this time you can turn the motor shaft to see if the panel is normally reading the Z-axis coordinate value. It's a good idea to use the HMI panel of the 6563FG to check the version number of your control system and send it back to me

• aO5ZCpeb

  : Thank you for your help here the photo Greetings Matthias

• aO5ZCpeb

  Reply

  @aO5ZCpeb

  : For this I connected RYH401F6-VV2-ZC1, 28 *FFB 26 *FFA 29 FFB 27 FFA but no response, thank you for your effort

• Other 10 replies