chanelink logo
CHANELINK
English

Rotating image distortion

Categories:
Laser
57
2
See translation
2024-11-01

What I'm worried about is when I want to carve a circular logo on a water bottle, for example, if the image on Ligtburn is clean but distorted on my water bottle

laser

laser

laser

laser

I checked the rotation and support settings, but it had no effect
The rotation setting is good, and the belt is tightened.
Carving machine Atzer L2 36W
Rotaru AtomStack R1 Pro
Please help me, I'm going crazy

C

    • jessie

      2024-11-04
      Measure your engraved output and compare with design dimensions (to see if the problem is X or Y).
Also test correct flat output by designing 1 squares with 50mm side and 1 with 100mm then engrave in a piece of cardboard and check dimensions.
        See translation
        Reply
        • Tim Johnson

          : Hello, thank you for your reply. Flat, don't worry, the odds are good When rotating, I measured according to your requirements and found that the Y-axis is too large compared to the drawing (at 33.7 mm for light burning and 45 mm for real)

      Relevant recommendations
      Collect
      Report