How to avoid the problem of non closure in laser cutting

1、 Reason for the problem
In the process of laser cutting, if the cutting line is too small or the laser power is too low, there will be a problem of non closure. In addition, if the cutting speed is too fast, this problem is also prone to occur. In addition, the material of laser cutting can also affect the closure of the cutting, and if the material is too soft and easily deformed, it can also affect the closure.

2、 Solution method
1. Increase laser power. The problem of non closure is usually caused by insufficient laser power. Increasing the laser power can enhance the cutting force of the laser on the material, making the cutting smoother and solving the problem of non closure.
2. Slow down the cutting speed. Increasing the cutting speed can improve work efficiency, but too fast a speed can affect the cutting quality and lead to non closure issues. If you encounter the problem of non closure when using laser cutting, you can slow down the cutting speed appropriately to increase the closure rate.

3. Increase the thickness of the material. If the material is too thin, it is prone to deformation, which affects the closure of the cutting. Increasing the thickness of the material can make cutting smoother, thereby solving the problem of non closure.

4. Optimize cutting lines. When designing, it is possible to consider designing the cut lines as flat structures to avoid overly small cutting lines and reduce the occurrence of non closure issues.

In short, when encountering the problem of laser cutting not closing, as long as the specific cause is identified and eliminated one by one, this situation can be avoided.