What is the reason why laser marking cannot be cut in

1. When the vertical light is incorrect, adjust the vertical light and if necessary, readjust the light path.

 

2. If the focal length is not adjusted properly, please refocus.

3. Voltage instability, low voltage, and low laser current. You need to replace the voltage regulator with a larger one and increase the laser current output.

4. If the light outlet of the nozzle is blocked by splashes, the nozzle should be cleaned in a timely manner.

5. To prevent air blockage, it is necessary to clean the air pump, air filter, and air circulation path.

6. After the reflector and focusing lens are contaminated, clean them with cleaning solution.

7. Check if the laser tube is powered off, if so, replace the laser tube.

If the lighting control module on the motherboard malfunctions, replace the motherboard directly.

9. There is a potentiometer device. If the potentiometer setting is too small or there is a malfunction, adjust the potentiometer setting or replace the potentiometer.

10. The energy setting in the software is too small, please increase the energy.

11. Regarding material issues, please choose the appropriate material.

12. If the focusing lens has cracks or poor focusing effect, replace the focusing lens directly.

13. The laser tube has too much dirt and poor heat dissipation effect. The cooling water must be pure water or distilled water.