1. The X axis of the laser cutting machine moves in the opposite direction to the Y axis, and hits the side end. For this phenomenon, check whether the motherboard parameters are wrong, and stop the machine to check whether the motherboard parameter settings are wrong.
2. The control panel of the laser cutting machine displays normally, but the X axis and Y axis do not move. You can try to unplug the sensor terminal of the motherboard to see if the machine operates. In this case, it is necessary to consider replacing the sensor.
3. The beam resets normally, but the X-axis of the laser cutter does not reset. The motor wire or the motor shaft may be broken. In this case, the laser cutter needs to replace the motor wire or small motor.
4. The direction is correct when resetting, but the X axis or Y axis cannot stop at the vertex (check the motherboard parameters first). If it is correct, check the motherboard or sensor, and replace it to eliminate this phenomenon.
Source: Yiqiang Laser
