Origin readings Y-390 and X-279

Try enabling CNC mode

• LWE

  : thank you for replying. I turned on cnc and it put the origin just the opposite in the positive. If I change the origin between top right and bottom left the laser position does just the opposite.

Enter G10 L2 P1 X-279 Y-390 in the Console window. This should tell your machine to operate in the first quadrant, which is where Lightburn is happy.

• LWE

  : Thank you for your help. I’m a little new to this so bare with me, when you say console window you mean in light burn where you type commands?
• Keegan

  답글

  @LWE

  : That is correct.