English

Unsupervised physical neural network empowers stacked imaging denoising algorithm

109
2025-03-25 15:23:55
See translation

In view of the reconstruction problem of stack imaging technology in noisy environment, Lin Nan's team from Shanghai Institute of Optics and Mechanics, Chinese Academy of Sciences, proposed an innovative method ProPtyNet based on unsupervised physical neural network, which is expected to be applied to chip CD measurement and defect detection. The article was published in Optics and lasers in engineering under the title of "Noise robust photography using unsupervised natural network".
Its core innovations and achievements are as follows:

1. Core issues and challenges
Stacked imaging uses diffraction patterns to invert the complex amplitude distribution of objects, but faces challenges in the following scenarios:
Complex noise environment: Poisson noise (signal-to-noise ratio 24.64dB) under low light conditions and mixed noise caused by random high-energy particles can lead to the failure of traditional algorithms
Dynamic bandwidth imaging: Non monochromatic light sources make non target wavelengths a new frequency domain noise source
Hardware limitations: Traditional iterative algorithms are slow and difficult to achieve fast imaging.

2. Method innovation
Propose a dual driven framework of "physical model+deep learning"
Data processing architecture: Zero padding preprocessing (e.g. 512 → 612 pixels) and four component output (amplitude/phase x object/probe) are used to improve axial resolution
Network topology optimization: Customize U-net architecture (with only 2.5 million parameters) to achieve four-dimensional parameter joint optimization, and extend the dynamic range of the "Conv2d tanh" phase layer to 2 π
Anti noise loss function: pioneering a dual loss mechanism (β=0.85-0.95) to balance overexposed areas (γ=1 → 0.1 gradient) and probe structured constraints, resulting in a 5-fold decrease in loss function

3. Experimental verification
Verify performance through 600 sets of tests:
Noise robustness: Under mixed noise (SNR 30dB), the SSIM value reaches 0.92 ± 0.03, which is about 14 times higher than ePIE
Speed advantage: The single convergence time is 729 seconds, which is 47.8% and 31.9% faster than AD and ePIE, respectively
Wide spectral adaptability: effectively separates ± 5nm noise components in the 405nm band, achieving a resolution of 57 line pairs/mm

4. Application prospects
Extreme Ultraviolet EUV Imaging: The method has been adapted to the Fresnel propagation model and can be extended to a wavelength of 13.5nm
Low dose dynamic monitoring: Effective suppression of readout noise under 300 μ s short exposure conditions (NPS=0.12)
Multi parameter joint calibration: achieving joint calibration along the axis (zPIE) and oblique incidence (aPIE) by adding output channels [35-36]
This study provides a breakthrough in both computer principles and experimental models for coherent imaging of new light sources (X-ray/EUV) and extreme operating conditions (low temperature/irradiation).


Figure 1. ProPtyNet algorithm details. (a) ProPtyNet network flowchart. (b) Details of U-net network architecture. (c) Data preprocessing and post-processing methods.


Figure 2. Simulation reconstruction results. (a) The true amplitude and phase of objects and probes. (b) The reconstruction results of ProPtyNet, ePIE, rPIE, and AD algorithms under Poisson noise, Gaussian noise, and mixed noise.


Figure 3. Experimental results. (a) The reconstruction results of sample amplitude information under different noise environments. (b) Comparison of amplitude cross-sections in the underlined section. (c) Comparison of loss functions in the iterative process.


Figure 4. Reconstruction results under broad-spectrum illumination (a) Experimental illumination light spectrum. (b) Simulation and experimental results.

Source: opticsky

Related Recommendations
  • Huagong Technology: Exploring the "Laser+" Strategy to Deliver the Powerful Productivity of Laser and Intelligent Manufacturing to Various Parts of the World

    What is the power of a beam of light? If light is used in the manufacturing field, its highest accuracy can reach one percent of the diameter of a hair thread, which is why it is called the "brightest light", "most accurate ruler", and "fastest knife". From airplanes and ships to kitchens and electrical appliances, lasers are widely used as advanced processing tools in all aspects of equipment man...

    2023-10-12
    See translation
  • Scientists develop flat-topped laser beams to overcome Gaussian distribution limitations

    The beam emitted by almost all laser systems follows the Angle pattern of Gaussian distribution. The Gaussian irradiance distribution means that irradiance has a smooth peak at the center point and slowly declines toward the edge. In theory, the irradiance level of a Gaussian distribution can never reach zero, which means that the distribution can expand indefinitely. This phenomenon in the laser ...

    2023-08-04
    See translation
  • Nikon launches COOLSHOT 20i GIII laser rangefinder with two measurement display modes: golf and actual distance

    Nikon Vision, a subsidiary of Nikon Corporation, is pleased to announce the launch of the COOLSHOT 20i GIII laser rangefinder for golfers, which is Nikon's small and lightweight model in the COOLSHOT series.While maintaining the lightweight and compact size of the COOLSHOT 20i GII, the new model notifies users through brief vibrations that the distance to the flagpole has been measured.When measur...

    2024-03-27
    See translation
  • New Progress: III-V Laser and Silicon Optics Technology Achieve Single Chip High Integration

    Recently, Scientific Photonics, a supplier of silicon photonic integrated circuits (PICs) headquartered in Grenoble, announced that it has successfully integrated III-V-DFB lasers and amplifiers with standard silicon photonic technology into the production process of Tower Semiconductor.By utilizing proprietary technology and standard silicon photonics, Scientific Photonics has achieved full inte...

    2024-03-01
    See translation
  • Micro laser opens the door to chip size sensors

    The new device is a frequency comb - a special type of laser that can generate multiple wavelengths of light, each with a fixed frequency interval. On the spectrogram, it looks a bit like the teeth of a comb. In approximately a quarter century since their first development, these "cursor rulers" have completely transformed various high-precision measurements from timing to molecular detection. In ...

    2024-03-13
    See translation