chanelink logo
CHANELINK
English

Problem with diode laser [ Sculpun S30 Pro Max ]

Categories:
Laser
Tags:
130
1
See translation
2023-06-06

Hello ,
I’m having a problem with my laser, but I’m not entirely sure what’s going on.

I set up zero pieces, adjusted the focus, and started cutting my file.
When the piece was finished, I wanted to run another cutting pass because it was apparent that it didn’t fully cut through the 4mm plywood. Initially, I performed a frame option just to double-check everything, but unfortunately, the entire file was offset by approximately 10mm, and I can’t seem to restore it to its original position.

I should mention that I didn’t remove the plywood from the honeycomb bed; it remained secured with pins.
I just wanted to run another pass, and that’s when this issue occurred.

How can I resolve this? Has anyone had a similar experience?

I’m using absolute coordinates.

C

    • Tory

      2023-06-07
      Yes, I had the problem too. When you home the laser head, the homing micros offset the starting point. There is an enter you can make to make sure the position after homing is 0,0. I am sorry but I don’t have this handy.

What I did do is go into the device setting and set the finishing position to x:390, y:30. This way when the job is complete, the laser head would move to the back and out of the way. ( I don’t have it set now because I am using the rotary. )
      See translation
      Reply
    Relevant recommendations
    Collect
    Report