Home position and laser position not the same
Categories:
Laser
94
1
0
2023-10-18
I recently updated my sculpfun s9 with limit switches, following the youtube video provided, i learned that where the laser hits the limit switches and where Lightburn sees the laser, is not the same. Lightburn sees it at being X: -377.00 Y: -392.00 Z: 0.00. Would there be a way to make its current position the new 0,0 ?
C
Marshall
2023-10-19"X: -377.00 Y: -392.00 Z: 0.00" Is this the reported position after homing? If so, try running these commands in Console: G10 L2 P1 X-377Y-392 $10=0 $H ? What is the reported position after running those commands?
0Reply
Relevant recommendations
- 2024-04-08
-
How should I fix for alarm 9?
2 Replies2024-09-23 - 2023-05-10
- 2024-09-18
