chanelink logo
CHANELINK
English

Xtool D1 pro with extensions not going home

Categories:
Laser
Tags:
293
1
See translation
2023-03-03

Everything else seams to be working fine with the exception of the home tab. When I press the home button it acts like the extensions are not there. I have checked the setting and uninstalled and reinstalled the xtool. Not sure where to go from here.

 

C

    • Smith

      2023-03-04
      For most GRBL and open source laser engraver controllers in general, the Machine Settings are available to be written to by the user.
xTool has a closed source model and some have found that changes to the settings do not survive a power (on-off-on) cycle.
If you’re inclined to test for yourself, you may have access to adjust the axis length setting for yourself.
The X-axis length setting is $130. The Y-axis length is $131.
From the Console window in LightBurn, with the engraver connected, please request the System Information and Machine Settings by typing the following:
$i
$$
pressing enter after each line.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report